Page 3 of 3 FirstFirst 123
Results 21 to 24 of 24

Thread: cac1959's customs

  1. #21
    Administrator and PCD Super Guesser cac1959's Avatar
    Join Date
    May 2011
    Location
    Richmond, Indiana
    Posts
    8,094
    Blog Entries
    10
    Thanks to PCD member Toyfountain for posting directions on creating custom pittys using Nat McLugnet and Michael Honksel on the Facebook page... He told me that it was easy enough that even I could do it... He was right... I worked on it this morning and got done in about 15 minutes.

    1. Start with 2 Nat McLugnut and Michael Honksel Pitty singles:



    2. Open them:


    (Left to Right: Nat, Michael, Nat, Michael)

    3. Using a small Phillips screwdriver, take them apart - each is held together by a single screw.



    4. Nat's in 3 pieces:


    5. Michael's in 3 pieces:


    6. I think I swapped the bottom pieces and then assembled and tightened the screw:


    7. Assemble the other one:


    Left to right: Nat McLugnut, Nat Honksel, Michael Honksel, Michael McLugnut


    Thanks for the heads up and encouragement, Toyfountain!


    I am cac1959... I am a Cars-a-holic... and a proud supporter of Nathan's Playroom

  2. #22
    Super Moderator GotFrank's Avatar
    Join Date
    May 2011
    Location
    Quad Cities, IL USA
    Posts
    1,536
    Nice thinkin' Lincoln!

  3. #23

  4. #24
    Administrator and PCD Super Guesser cac1959's Avatar
    Join Date
    May 2011
    Location
    Richmond, Indiana
    Posts
    8,094
    Blog Entries
    10
    Here are a couple of new customs thanks to Scavenger:

    Brian Fee Apple Clamp:




    With a custom made from Dexter Hoover many years ago:


    Here's Rev N Go Cab (made from Dinoco Cab):


    With Rev N Go racer:


    Many thanks, Scavenger!


    I am cac1959... I am a Cars-a-holic... and a proud supporter of Nathan's Playroom

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •